Search results

I hope it works out for you. In my years of off the job engineering projects , both pre and post retirement, I have never had a project cost what I told my wife it would cost. But I always considered myself an average engineer who has an obsessive compulsion to constantly make it a bit be$$er...

I understand your point,. My concern is that one wrong move on the design testing and the damage may far exceed $250 savings potential.

based on the cost of that knowledge, I think the $325 is actually a pretty good bargain.

are you talking about this from z automotive"? https://www.zautomotive.com/products/z_sgw_ext?variant=45935990833318&gad_source=1&gad_campaignid=21766573635&gbraid=0AAAAAoXL-WGPB3YXdEMJuc7fOr1rqacbE&gclid=EAIaIQobChMI6NWG24n2lAMVuidECB3PVSqWEAQYBSABEgKaJvD_BwE

Well I’m answering my own questions today. Deactivated the side markers and everything still woks as expected, those codes are now gone. Now I just have to chase down a pesky C0175-74 code on the ABS

Thoughts on using JScan to deactivate side marker lights? I have not done this yet. Anyone have thoughts on whether that would be a good plan?

So looks like that elbow fit nicely on the mishimoto, good to know😎

I installed bushwhacker fenders and led turn signals a while back. The turned signals work as I expected. I was running a diagnostic for another issue and got the following two codes - B17C1-11 and B17BC-11. RIGHT AND LEFT sidemarker lamp control circuit short to ground. I’m guessing that...

Call them directly. It’s a part of their spare tire carrier kit. I think they’ll sell it to you for around $30

My 2022 with 5 k miles is valued at 26 grand. California jeep. Just run. Do not spend that kind of money on a jeep with that many miles

Teraflex. I have the same setup for the factory rear view

I disconnected all my accessories, unplugged the IBS sensor, locked the car waited 3 hours, had a 80-90 mA drain tested all the micro fuses, no draw. Going to try again and pull the cartridge fuses one by one.

That first paragraph is really weird, at any rate, serious rock crawlers should ditch the OEM bumper on day one.

Thank you

Did you use any special clamps other than reconnecting with the OEM clamps on the silicone hose?

I’m going to try the metal one from Amazon. Comes with hoses as well. Just not sure if I want to keep the OEM hoses , or use the silicone ones that came with the kit. Anyone have any option on the silicone hoses? https://a.co/d/059MtDYz

For your application the OEM bumper is a no.

I just want you guys to know, when you you see my overbuilt and under used jeep for sale, it’s cause I’m dead and my wife is just trying to money to buy fabric for quilting. So please be a bit kinder then. Thanks in advance 😎

I’m genuinely surprised 😳. Did your coolant tank fail on the 3.6?

I ordered just the replacement elbow and T from the Amazon supplier, they sent the whole kit, including the tank. At any rate has anyone tried the elbow on the Mishimoto tank yet? I’m going to wait until I see some leakage from under my tank, before I tear the whole thing apart and try it. the...